Epoxy

Best epoxy on planet earth NEVER worry about components again. A must have for all shops and archers

I have been using AAE epoxy for years now for bonding inserts into carbon arrows and crossbow bolts. Clean the carbon dust inside the shaft from the cutting process and I wipe the inserts with a degreaser to remove any oils. Never had any problems at all. No pulled inserts in targets. You have plenty of time to set the insert, check for proper alignment by spinning and make any necessary adjustments. Easy to use dispenser with a 1:1 ratio. The best epoxy out there for archery applications.

It was very easy to open and use for arrow inserts and I haven't had a problem with them yet

Very impressed with the overall, long term durability of this product. Typically I've used heat to remove epoxied target points (and to release epoxies in general) and in this case, it is not enough. I had one damaged target point that looked to be pulling out, and to get a real idea of the holding power, I put a torch to the target point to remove. Needless to say...it would not let go unless the temperatures were carbon destroying extreme. Consider it a permanent solution.

Good stuff. Plenty of working time, and a pair of tubes is good for about 7 dozen arrows 😂. I used these to epoxy in target points